Microsoft Windows NT 4.0 Guide Guia do Utilizador descarregar pdf (Página 20)

TouchWare for Windows NT User's Guide20

To copy and extract the Microcal files to a system running MS-DOS:

1. Shut down and exit from Windows NT.

2. Boot your system into MS-DOS.

3. Wait until the system displays the MS-DOS command line prompt.

For example:

A:\> or C:\>

4. Insert the TouchWare for Windows NT diskette into the disk drive.

5. Use the Make Directory command to create a new directory for

the MicroTouch files. MicroTouch recommends you name the

directory \MTSNT (for MicroTouch Systems, Windows NT):

C:\> MD \MTSNT

6. Use the Change Directory command to switch to the directory you

just created:

C:\> CD \MTSNT

7. Enter the following command to copy the MICRO.EXE file from

the diskette to the current directory:

C:\MTSNT> COPY drive-designator:\MICRO.EXE

where drive-designator is the letter that represents the diskette

drive you are currently using. For example, use A: if you are using

Drive A.

8. Run the MICRO.EXE file to extract the Microcal files.

C:\MTSNT> MICRO.EXE

The system displays the following messages:

Searching EXE: C:/MTSNT/MICRO.EXE

Inflating: MCAL.OVL

Inflating: MICROCAL.EXE

Inflating: MICROCAL.HLP

Inflating: QCAL.OVL

Inflating: QUICKCAL.HLP

For information about using Microcal, refer to Chapter 4.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 143 144

Sem comentários

Microsoft Windows NT 4.0 Guide Guia do Utilizador Página 20